Buscar
Filtrado por:
Fecha de creacion
2005-09
Eliminar la restricciónFecha de creacion: 2005-09
1 - 2 de 2
El número de resultados a mostrar por página
Resultados de la búsqueda
- Type:
- Article
- Descripción/Resumen:
- Bacterial methionine aminopeptidase (MAP) is a protease that removes methionine from the N termini of newly synthesized bacterial proteins after the peptide deformylase enzyme cleaves the formyl group from the initiator formylmethionine. MAP is an essential bacterial gene product and thus represents a potential target for therapeutic intervention. A fundamental challenge in the antibacterial drug discovery field is demonstrating conclusively that compounds with in vitro enzyme inhibition activity produce the desired antibacterial effect by interfering with the same target in whole bacterial cells. One way to address the activity of inhibitor compounds is by profiling cellular biomarkers in whole bacterial cells using compounds that are known inhibitors of a particular target. However, in the case of MAP, no specific inhibitors were available for such studies. Instead, a genetically attenuated MAP strain was generated in which MAP expression was placed under the control of an inducible arabinose promoter. Thus, MAP inhibition in whole cells could be mimicked by growth in the absence of arabinose. This genetically attenuated strain was used as a benchmark for MAP inhibition by profiling whole-cell lysates for unprocessed proteins using surface-enhanced laser desorption ionization–time of flight mass spectrometry (MS). Eight proteins between 4 and 14 kDa were confirmed as being unprocessed and containing the initiator methionine by adding back purified MAP to the preparations prior to MS analysis. Upon establishing these unprocessed proteins as biomarkers for MAP inhibition, the assay was used to screen small-molecule chemical inhibitors of purified MAP for whole-cell activity. Fifteen compound classes yielded three classes of compound with whole-cell activity for further optimization by chemical expansion. This report presents the development, validation, and implementation of a whole-cell inhibition assay for MAP.
- Creador/Autor:
- Siehnel, Richard; Howard, Jeremy; Zhou, Songtao; Layh-Schmitt, Gerlinde; Greis, Kenneth D.; Curnow, Alan, and Klanke, Chuck
- Peticionario:
- Kenneth Greis
- Fecha modificada:
- 03/03/2017
- Fecha modificada:
- 04/07/2017
- Fecha de creacion:
- 2005-09
- Licencia:
- All rights reserved
- Type:
- Article
- Descripción/Resumen:
- A short computational program was undertaken to evaluate the effectiveness of a closed-loop control strategy for the stabilization of an unstable bluff-body flow. In this effort, the non-linear one-dimensional Ginzburg–Landau wake model at 20% above the critical Reynolds number was studied. The numerical model, which is a non-linear partial differential equation with complex coefficients, was solved using the FEMLAB®/MATLAB® software packages and validated by comparison with published literature. At first, a model independent approach was attempted for wake suppression using feedback control. The closed-loop system was controlled using a conventional proportional-integral-derivative (PID) controller as well as a non-linear fuzzy controller. A single sensor is used for feedback, and the actuator is represented by altering the boundary conditions of the cylinder. Simulation results indicate that for a single sensor scheme, the increase in the sophistication of the control results in significantly shorter settling times. However, there is only a marginal improvement concerning the suppression of the wake at higher Reynolds numbers. The feedback control design was then augmented by switching over to a model-dependent controller. Based on computationally generated data obtained from solving the unforced wake, a low-dimensional model of the wake was developed and evaluated. The low-dimensional model of the unforced Ginzburg–Landau equation captures more than 99.8% of the kinetic energy using just two modes. Two sensors, placed in the absolutely unstable region of the wake, are used for real-time estimation of the first two modes. The estimator was developed using the linear stochastic estimation scheme. Finally, the loop is closed using a PID controller that provides the command input to the variable boundary conditions of the model. This method is relatively simple and easy to implement in a real-time scenario. The control approach, applied to the 300 node FEMLAB® model at 20% above the unforced critical Reynolds number stabilizes the entire wake. Compared to the model-independent controllers, the controller based on the low-dimensional model is far more effective in the suppression of the wake at higher Reynolds numbers. Furthermore, while the latter approach employs only the estimated temporal amplitude of the first mode of the imaginary part of the amplitude, all higher modes are stabilized. This suggests that the higher order modes are caused by a secondary instability that is suppressed once the primary instability is controlled.
- Creador/Autor:
- Myatt, James; Cohen, Kelly; Siegel, Stefan; McLaughlin, Thomas, and Gillies, Eric
- Peticionario:
- Kelly Cohen
- Fecha modificada:
- 02/10/2017
- Fecha modificada:
- 04/05/2017
- Fecha de creacion:
- 2005-09
- Licencia:
- All rights reserved