Buscar

Borrar filtros
Filtrado por: Fecha de creacion 2009-06 Eliminar la restricciónFecha de creacion: 2009-06 Departamento Aerospace Engineering and Engineering Mechanics Eliminar la restricciónDepartamento: Aerospace Engineering and Engineering Mechanics

Resultados de la búsqueda

  • Spatially Distributed Forcing and Jet Vectoring with a Plasma Actuator

    Article thumbnail: Spatially Distributed Forcing and Jet Vectoring with a Plasma Actuator
    Type:
    Article
    Descripción/Resumen:
    The ability to spatially alter both the amount of body force along the span of a plasma actuator and the angle of the resulting jet relative to the surface has been demonstrated. A dielectric barrier discharge plasma actuator consists of two electrodes separated by a dielectric barrier, which imparts momentum to the surrounding fluid parallel to the dielectric. To investigate a technique to shape the spanwise body force created by the plasma actuator, a control volume momentum balance was used. By shaping the buried electrode along the span of the actuator, the local volume of plasma generated can be controlled, which is related to the local body force. Pressure measurements were taken in the boundary layer behind the actuator to calculate the momentum imparted to the flow at various spanwise locations corresponding to different electrode widths. Particle image velocimetry data were then used to show that spatially varying, steady jets could be created with the use of only one actuator by varying the width of the buried electrode in a quiescent flow. The angle of the jet created, relative to the dielectric, by a plasma synthetic jet is also investigated. By pointing two plasma actuators at each other, an inverted impinging jet can be created as a result of the two independent jets colliding. By altering the strength of one of the jets relative to the other, the angle of separation can be changed. Particle image velocimetry data were taken to show the effects of altering the voltage (strength) applied to one of the actuators relative to the other. It was found that, with this method, jet vectoring could be achieved. The angle of the jet could be controlled a full 180 deg through small changes in the voltage applied to the electrodes, also in a quiescent flow.
    Creador/Autor:
    Enloe, C. L.; Cohen, Kelly; Porter, C.; McLaughlin, T., and Abbas, A.
    Peticionario:
    Kelly Cohen
    Fecha modificada:
    02/13/2017
    Fecha modificada:
    04/05/2017
    Fecha de creacion:
    2009-06
    Licencia:
    All rights reserved